Seagate stkp160004021/18/2024 No lights on the Central's NIC: Make sure the Ethernet cable is plugged all the way through at both ends. Make sure you are connected into a LAN port on your router. If the NIC lights still don't illuminate, try powering down the Central by unplugging the power supply, then connect the drive into a different Ethernet port on your computer and power the Central back up. If you still don't get any lights on the NIC, try using a different Ethernet cable. If the NIC's lights still are not lit, move on to step 4.No lights at all: Make sure everything is plugged in properly. The Ethernet cable should be connected between the Seagate Central and your router. The power supply should be connected between the Seagate Central and a power outlet. If you still have no lights, try connecting the power supply in a different outlet. You can also try another power supply, as long as you have one with the same specifications. The power supply that comes with the Seagate Central has an output of 12V 2A. If you are still not getting any lights, move on to step 4.Seagate recommends waiting a good 7-10 minutes just in case. After 3-4 minutes, the light should settle down to a solid green. ![]() During the boot sequence, the LED on top of the drive will blink a few different colors and patterns, including amber and red. ![]() The Seagate Central takes about 3-4 minutes to fully boot. In the event that you are trying to set up the Seagate Central and are unable to find it on the network, Seagate recommends that you take a look at these troubleshooting steps.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |